Press a suction cup onto the screen, just above the home button.
Be sure the cup is completely on the screen to get a tight seal.
home button အထက္နား screen မွာ ေလစုတ္ခြက္ ကို တင္းတင္းက်ပ္က်ပ္ ေသခ်ာစြာ ကပ္ပါ...
Step 3
Make sure the suction cup is firmly attached to the front panel assembly.
While holding the iPhone down with one hand, pull up on
the suction cup to slightly separate the front panel assembly from the
rear case.
Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices.
With a plastic opening tool, begin to gently pry the rear
case down, away from the display assembly, while you pull up with the
suction cup.
There are several clips attaching the front panel
assembly to the rear case, so you may need to use a combination of the
suction cup and plastic opening tool to free the front panel assembly.
Once the clips have been released on the bottom and sides
of the front panel assembly, pull the bottom of the assembly away from
the rear case.
Do not try to completely remove the front panel assembly
from the rear case, as there are several ribbon cables still attached at
the top of the iPhone.
Lift and rotate the front panel assembly up to about 90 degrees from the rear case.
အေပၚကပံုေလာက္ပဲ 90 degrees ေျမာက္ထားပါ........
Step 6
Remove the following screws securing the front panel assembly cable bracket to the logic board:
Remove the front panel assembly cable bracket from the logic board.
Step 8
Use a plastic opening tool to disconnect the three front panel assembly cables:
Front-facing camera and sensor cable
Digitizer cable
LCD cable
When reassembling your phone, The LCD cable may pop off
the connector. This can cause white lines, or nothing at all to appear
when powering your phone back on. If that happens, simply reconnect the
cable and power cycle your phone.
Use a plastic opening tool to gently pry the battery connector up from its socket on the logic board.
Be very careful to only pry up on the battery connector
and not the socket on the logic board. If you pry up on the logic board
socket, you may break the connector entirely.
Insert the edge of a plastic opening tool between the battery and the rear case near the bottom the iPhone.
Run the plastic opening tool along the right edge of the
battery and pry up at several points to completely separate it from the
adhesive securing it to the rear case.
Do not pry up too hard, as this may permanently deform or puncture the battery.
0 - ဦး မှတ်ချက်ပေးထားပါသည်
Post a Comment